Pyronix STERLING 10 Manual do Utilizador Página 7

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 12
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 6
Sterling 10 User Manual
Page: 16 RINS415-9
3.6 System Faults
There are 4 fault conditions automatically detected by the Sterling 10. The user is informed of a fault
via a flashing '
' (LCD keypad) or '_' (Icon keypad) and an error tone will be emitted every 5
seconds when the panel is in disarmed mode. Press the function key to stop the error tone. The '
' or
'_' will remain on until the fault has been corrected.
LCD Keypad
To determine the fault go into the log by:
Pressing the key
Followed by the key.
The fault will be displayed:
Bell Fuse Failure.
Auxiliary Fuse Failure.
Telephone Line Failure.
Mains (AC) Failure.
Press to exit the log.
ICON Keypad
The symbol will be displayed.
Press the > key to see the fault as described below:
T
Bell Fuse Failure.
Z
Auxiliary Fuse Failure.
H
Telephone Line Failure.
U
Mains (AC) Failure.
Press C to exit the log.
Ente
r
Func
B
D
E
F
Enter
Func
Sterling 10 User Manual
RINS415-9 Page: 5
2.4 Arm with Omits
It is possible to arm the panel with one or more zones omitted (that is, not activated). The sensors for
these zones will not activate the alarm system under any circumstances for that arm procedure.
Enter your 4-digit code
Press the (LCD) or C(ICON) key
Followed by the key
Then enter the numbers of the zone to be omitted, (Zones 1 to 8). If, for example, you want to omit
Zone 1 (default text F DOOR), the following will be displayed:
Then press the (LCD) or C(ICON) key.
The Entry/Exit timer will start to countdown, once armed the chosen zone(s) will be omitted from that
arm mode only. Arming the panel in future will not have these omits enabled unless you omit the
zones again using the above function.
2.5 Disarming the Panel
The panel may be disarmed by entering the building via the Entry/Exit route and entering on the
keypad either the Master Code or any User Code.
2.6 Reset After Alarm Condition
After an alarm condition, enter the user code (Default 1234):
A
A
B
C
Y
Z
S
T
U
V
W
X
B
D
E
F
C
G
H
I
D
J
K
L
M
N
O
P
Q
R
Enter
SPACE
A
RM
Func
P.A.
Fire
STERLING
SYSTEM DISARMED
F DOOR
A
A
B
C
Y
Z
S
T
U
V
W
X
B
D
E
F
C
G
H
I
D
J
K
L
M
N
O
P
Q
R
Enter
SPACE
A
RM
Func
P.A.
Fire
STERLING
SYSTEM ARMED
ALARM LOUNGE
Enter
Func
Enter
Func
SPACE
Vista de página 6
1 2 3 4 5 6 7 8 9 10 11 12

Comentários a estes Manuais

Sem comentários